Stewart Audio - Sub Compact Amplifiers

Sub Compact Amplifiers

1/4 and 1/3 rack width amplifiers are an ideal solution for installations where an equipment rack is either full or not being installed.

Stewart Audio’s sub compact amplifiers can be located in places normally off-limits to ‘normal’ amplifiers. These convection cooled amps can be located in ceiling voids, attached to walls, furniture or even poles.

Single and dual channel sub compact amplifiers are readily available with Dante alternatives ,that are designed to be single cable solutions for smaller zones that don’t have easy access to a local power outlet.

AV25-2

The sub compact AV25-2 (2 x 25W) is built to meet the rigorous demands of high quality commercial, industrial and Pro Audio sound installations. Low cost, lightweight and convection cooling make this Class D amplifier flexible enough for a broad range of applications requiring quiet amplification. Its extremely compact form factor means you can install amplification in places usually out of bounds.

Like all Stewart products, the AV25 is designed for sonic accuracy, high efficiency, and extended duty cycles. Other versions of the AV-25 are available including the AV-25-RS232 which is equipped with RS-232 control capability, the AV-25-Net, which is Dante enabled, and the AV-25-Net+ which has both Dante and local I/O.

Stewart Audio - AV25-2 - Sub Compact Amplifiers

Stewart Audio - CVA25-1 - Sub Compact Amplifiers

CVA 25-1

The CVA 25-1 is a mono sub compact amplifier – 25W x 1 @ 70V/100V, which has an extremely compact form factor, allowing amplification to be located in places normally off limits to standard amplifiers without compromising sound or power.

  • Sub Compact 1/4 Rack Package
  • Mono Constant Voltage Amplifier (70V or 100V)
  • Music and Fire Alarm Muting
  • Clean Full-Range Dynamic Power
  • Signal Detect Trigger for Sleep and Wake Up

CVA 50-1

The sub compact CVA-50-1 (1 x 50W @ 70/100V) amplifier is built to meet the rigorous demands of high quality commercial, industrial and Pro Audio sound installations. Low cost, lightweight and convection cooling make this Class D amplifier flexible enough for a broad range of applications requiring quiet amplification. Its extremely compact form factor allows the amplifier to be installed in locations typically out of bounds.

Like all Stewart products, the CVA’s are designed for sonic accuracy, high efficiency, and extended duty cycles. Other versions of the CVA-50 are available including the CVA-50-Net, which is Dante enabled, and the CVA-50-Net+ which has both Dante and local I/O.

Stewart Audio - CVA50-1 - Sub Compact Amplifiers